Configure The Fcip Routes Using The Cli; Step 7. Configure Fc Switch Settings For The Mpx200; Configuring The Fcip Routes Using The Cli - HP StorageWorks 6400/8400 - Enterprise Virtual Array User Manual

• TCP Windows size
• TCP Windows scaling factor
• Use the recommended setting documented in this guide for the actual bandwidth and RTT of
the link
• Software compression
• Enable compression for IP links with round-trip time (RTT) >= 50 milliseconds or a guaranteed
WAN bandwidth <= 155 Mb/s.
NOTE:
HP recommends that you accept the default settings for TCP Port and GE Port Speed. If you need to
change the port speed, select Full Duplex mode; Half Duplex mode is not supported.

Configure the FCIP routes using the CLI

For each MPX200, configure the FCIP route information as shown in
Figure 86 Configuring the FCIP routes using the CLI
.

Step 7. Configure FC switch settings for the MPX200

Execute the following commands for all B-series FC switches that will use the FCIP link:
• B-Switch# switchdisable
• B-Switch# iodset
• B-Switch#aptpolicy 1
B-Switch#portcfgIslmode [ slot/ port ], 1 (Must be set for all MPX200 FCIP FC ports regardless
•
of storage types)
• B-Switch# portcfggport [ slot/ port ] ,1 (set for all MPX200 FCIP FC ports)
• B-Switch# switchenable
For C-series FC switches, execute the following commands for each VSAN that will use the FCIP link.
Enter one command per line.
• C-Switch# config
• C-Switch(config)# in-order-guarantee VSAN n (where n stands for all VSANs that use the
FCIP link)
Figure 86:
MPX200 Multifunction Router 137