Setting Array Properties In The Cli; Setting Array Bandwidth - HP StorageWorks 6400/8400 - Enterprise Virtual Array User Manual

To set the array bandwidth:
1. On the Information page of the selected array, click Array Bandwidth, and then click one of the
following values:
• Slow (50 MB/s)
• Medium (200 MB/s)
• Fast (1600 MB/s)
• Throttle
2. If you select Throttle, enter a value between 1 and 400 in the User Defined Bandwidth (MB/s)
box. (Figure 90
Figure 90 Setting array bandwidth
.
3. To save your changes, click Save.
4. In the Security Check dialog box, enter the administrative password. (The default password is
migration.)
The mpx Manager displays an informative message indicating that the array properties have
changed.
5. Click OK to close the message box.
6. To apply the changes and update the window, click Refresh.

Setting array properties in the CLI

Follow these steps to change the array properties using the CLI. Note that all data migration operations
are authorized only to the migration administrator session, miguser. For more information, see
Miguser session.
1. Log in to the MPX200 as guest and enter the password.
shows an example.) By default, the MPX200 uses all available bandwidth.
MPX200 Multifunction Router 153