Figure 15. Attaching The Heat Sink And Retention Clip - Intel SE7501CW2 - E7501 DUAL PGA604 XEON 533MHZ Product Manual

3. Align the heat sink over the processor and set it into place. If your heat sink has a flat end on it,
the flat end must point toward the rear of the chassis.
4. Position the retention mechanism clips over the plastic tabs at the center of the retention
mechanism. Note that the slot in the clip provides room for side-to-side motion. Push down on
the top of each retention clip while sliding it to over. (Figure 15, 1).
5. Engage each end of the retention mechanism clips over the plastic tabs at the sides of the
retention mechanism (Figure 15, 2).
6. Press downward on the ends of the retention mechanism clips to lock them into place over the
plastic tabs (Figure 15, 3 and 4).
NOTES
The 400 MHz Intel Xeon processor and the 533 MHz Intel Xeon processor
use different retention mechanism clips. Although the clips appear to be
nearly identical, they vary slightly in size. Use only the clips that came with
your processor.
For both the 400 MHz clips and the 533 MHz clips, make sure the center tab
on the clip engages in the heat sink base.
60
C
B
C
1
D
2

Figure 15. Attaching the Heat Sink and Retention Clip

A
E
3
4
Intel Server Board SE7501CW2 Product Guide
TP00099