Installing The Processor Wind Tunnel; Attaching The Heat Sink; Attaching The Wind Tunnel Assembly - Intel SE7500CW2 Product Manual

Attaching the Heat Sink

1. Align the heat sink with the retention brackets and place the heat sink on the processor.
2. Position the retention clip over the plastic tab and engage the clip end-slot over the plastic tab.
3. Press downward on the retention clip ends until they engage the plastic tabs.

Installing the Processor Wind Tunnel

Attaching the Processor Wind Tunnel Assembly
Install the processor wind tunnel center section over the heat sink (Figure 15). Note that the plastic
tabs engage the tabs on the retention clips.
58
1 1
3
Figure 14. Attaching the Heat Sink
Figure 15. Attaching the Wind Tunnel Assembly
3
OM14474
OM14475
Intel Server Board SE7500CW2 Product Guide