Installing Or Replacing Memory; Figure 11. Installing Memory - Intel SE7501CW2 - E7501 DUAL PGA604 XEON 533MHZ Product Manual

Installing or Replacing Memory

The server board supports only DDR200- and DDR266-compliant DIMMs. Install from 128 MB to
8 GB of memory, using up to four DIMMs.
Memory must be installed according to the following rules:
DIMM 1A must be populated first. This DIMM the closest to the edge of the board.
When only a single DIMM is to be used, that DIMM must be inserted into slot 1A.
When Bank 2 is used, both slots must be populated and Bank 1 must be fully populated with
two DIMMs.
No DIMM mixing is allowed within a bank. Between banks only the DIMM size may be different.
All DIMMs must be the same speed and architecture. For a list of supported memory, visit the Intel
Support Web site:
http://support.intel.com/support/motherboards/server/SE7501CW2
4
DDR200-compliant ECC DIMMs can be used only if 400 MHz processors are installed.
56
4
3
1

Figure 11. Installing Memory

2
3
1
TP00089
Intel Server Board SE7501CW2 Product Guide