Installing Chassis Standoffs; Figure 6. Installing Chassis Standoffs In The Sc5200 - Intel SE7501CW2 - E7501 DUAL PGA604 XEON 533MHZ Product Manual

Installing Chassis Standoffs

Standoffs are included with your chassis. For the Intel® Server Chassis SC5200 and the Intel®
Server Chassis SC5250-E, the locations where standoffs need to be installed are shown below.
If you are using a non-Intel chassis, you must rearrange the standoffs so they match the holes in the
server board. Failure to properly rearrange the metal standoffs may cause the server board to
malfunction and may permanently damage it. If your chassis does not include a hole for a
particular standoff, install the adhesive-backed standoff that is included with your server board.
Your chassis may be different from the illustrations below.
®
Intel Server Chassis SC5200
®
The Intel Server Chassis SC5200 comes with standoffs pre-installed in positions 1, 4, 6, 20, 23,
and 26. Install standoffs in positions (7, 18, 19, P, and S).
52
1
4
6

Figure 6. Installing Chassis Standoffs in the SC5200

7
20
P P
P P
P
P
P P
18 23
S
19
26
OM14221
Intel Server Board SE7501CW2 Product Guide