Intel SE7501CW2 - E7501 DUAL PGA604 XEON 533MHZ Product Manual page 30

Table 12. I/O Device Configuration Submenu (continued)
Feature
Mode
(This feature is present
only when Parallel Port is
set to Enabled)
Base I/O Address
(This feature is present
only when Parallel Port is
set to Enabled)
Interrupt
(This feature is present
only when Parallel Port is
set to Enabled)
DMA channel
(This feature is present
only when Parallel Port is
set to Enabled)
Floppy disk controller
30
Choices Description
Sets the mode for the parallel port.
Output only
Output only is the standard printer connection mode.
Bi-directional
Bi-directional is the standard bidirectional mode.
EPP
EPP is Enhanced Parallel Port mode, a high-speed
ECP (default)
bidirectional mode. Selection based on what EPP version
the printer supports. Only choose a mode that the parallel
port device (such as a printer) supports. Check the
parallel port device documentation for this information. If
this information cannot be located, use the default setting.
ECP is Extended Capabilities Port mode, a high-speed
bidirectional mode.
Sets the base I/O address for the parallel port.
378 (default)
278
3BC
Sets the interrupt for the parallel port.
IRQ5
IRQ7 (default)
Sets the DMA channel for the parallel port.
DMA 1
DMA 3
(default)
Enables or disables the onboard diskette controller.
Disabled
Enabled
(default)
Intel Server Board SE7501CW2 Product Guide