Minimum Hardware Requirements
To avoid integration difficulties and possible board damage, your system must meet the following
minimum requirements. For a list of qualified memory and chassis components see:
http://support.intel.com/support/motherboards/server/SE7501CW2
Processor
A minimum of one 1.8 GHz Intel Xeon processor with 512KB cache support is required. For a
complete list of supported processors, see:
http://support.intel.com/support/motherboards/server/SE7501CW2
Memory
A minimum of one or two 128 MB Registered, ECC, DDR200- or DDR266- compliant, 184-pin
3
DIMMs.
Power Supply
A minimum of 450W is required. Your supply must provide a minimum of 1.2 A of 5 V standby
current or the board will not boot.
Installation Notes
Installation Process Quick Reference
Step
Remove the access cover
Install the I/O shield
Install memory
Install the standoffs
Install the rubber bumpers
Install the server board
Install the primary processor
Install the secondary processor
(optional)
Connect cables to the server
board
3
DDR200-compliant ECC DIMMs can be used only if 400 MHz processors are installed.
Server Board Installation
Where the information is located
Your chassis manual
This guide
This guide
This guide
This guide
This guide
This guide
This guide
This guide and your chassis manual
49