Snmp Commands - HP StorageWorks 2/32 - SAN Switch Release Note

Fabric OS Commands

SNMP Commands

The following SNMP commands are included with this release of firmware.
loopporttest Command
A new admin level command, loopporttest, has been added to this release.
This command enables the administrator to perform a functional test of L_port
M->M path on a loop.
Description
Use this command to verify the operation of the switch by sending frames from
the port M transmitter, and looping the frames back through an external fiber
cable, including all the devices on the loop, into the port M receiver. This
exercises all the switch components from the main board to the SFP to the fibre
cable to the SFPs (of the devices and the switch) and back to the main board.
The cables and SFPs connected should be of the same technology: meaning that a
port with a short wavelength SFP is connected to another device with a short
wavelength SFP using a short wavelength cable; and a long wavelength port is
connected to a long wavelength port; and a copper port is connected to a copper
port.
Only one frame is transmitted and received at any one time. The port LEDs flicker
green rapidly while the test is running.
The test method is as follows:
1. Determine which ports are L_ports.
2. Enable ports for cabled loopback mode.
3. Create a frame F of data size (1,024 bytes).
4. Transmit frame F via port M, with D_ID to the FL port (ALPA = 0).
5. Pick up the frame from port M, the FL port.
6. Check if any of the 8 statistic error counters are non-zero: ENC_in, CRC_err,
7. Check if the transmit, receive or class 3 receiver counters are stuck at some
8. Check if the number of frames transmitted is not equal to the number of
9. Repeat steps 3 through 8 for all ports present until the number of frames
24
TruncFrm, FrmTooLong, BadEOF, Enc_out, BadOrdSet, DiscC3.
value.
frames received.
requested is reached, all ports are marked bad.
SAN switch 2/32 Version 4.0.2b Release Notes