HP StorageWorks 2/32 - SAN Switch Release Note page 39

This parameter is required on the Standby CP. This parameter is not used on the
Active CP. You must follow -s with the switch instance number where the
command is to be executed. Valid values for switch instance are 0 (for the switch
instance associated with slots 1 though 4) or 1 (for the switch instance associated
with slots 6 though 10).
p - Clear messages ONLY from the persistent error log.
Example
The following example shows how to clear the current run time error log on the
Active CP:
See Also
errDump, errShow, errNvLogSizeSet, errNvLogSizeShow
SAN switch 2/32 Version 4.0.2b Release Notes
switch:admin> errClear
The following example shows how to clear the persistent error
log on the Active CP.
switch:admin> errClear -p
The following example shows how to clear the current run time
error log on the Standby CP, for the switch instance 0.switch:
admin> errClear -s 0
The following example shows how to clear the persistent error
log on the Standby CP, for the switch instance 0.
switch:admin>errClear -s 0 -p
Fabric OS Commands
39