HP StorageWorks 2/32 - SAN Switch Release Note page 13

7. Reissue the haShow command from the switch IP session, as follows:
8. From the switch IP address issue the haFailover command. This causes
9. It is necessary to re-telnet into the switch IP address due to the failover. The
10. Issue the haShow command and monitor the haShow command output,
11. Telnet into the standby CP card (now CP0) and issue the
SAN switch 2/32 Version 4.0.2b Release Notes
ter1_127:admin> haShow
Local CP (Slot 6, CP0): Active.
Remote CP (Slot 5, CP1): Non-Redundant ?This says the standby CP
is still rebooting.
ter1_127:admin> haShow
Local CP (Slot 6, CP0): Active
Remote CP (Slot 5, CP1): Standby <- Standby CP has completed
rebooting and ready to become the active CP.
HA Enabled, Heartbeat Up
the active CP card to failover to the standby CP card. The standby CP card
then becomes the active CP card, and the active CP card reboots and becomes
the standby CP card.
switch IP address is now controlled by the new active CP card.
which should look similar to the following:
ter1_127:admin> haShow Local CP (Slot 6, CP1): Active <----- The
active CP is now CP1.
Remote CP (Slot 5, CP0): Non-Redundant <----- This says the
original CP is still rebooting.
ter1_127:admin> haShow
Local CP (Slot 6, CP1): Active
Remote CP (Slot 5, CP0): Standby <------- CP0 is now ready to do
firmwareDownload.
HA Enabled, Heartbeat Up
When the reboot is complete the haShow output should look as
follows:
ter1_127:admin> haShow
Local CP (Slot 6, CP1): Active
Remote CP (Slot 5, CP0): Standby <------- CP0 is now ready to do
firmwareDownload.
HA Enabled, Heartbeat Up
firmwareDownload command. Make sure that both the reboot option and
the firmwareCommit option are executed. It is NOT necessary to perform a
Firmware Upgrade Procedures
13