HP StorageWorks 2/32 - SAN Switch Release Note page 47

To disable sending of error log messages to a previously enabled remote
syslogd host do the following:
1. Login to the switch as Admin user.
2. At the command line enter the syslogdipremove command as follows:
3. Verify the IP address was deleted using the syslogdipshow command.
syslogd Configuration on the Remote Host
The syslogd configuration on the UNIX host provides the syslogd daemon
with instructions on how to process different messages it receives from the switch.
The following are example entries in the syslog configuration file,
/etc/syslog.conf, on how to store switch error log messages received from
the switch.
Note:
documentation of the syslog configuration file.
Example
The following entry in /etc/syslog.conf causes all messages (Debug, Info,
Warning, Error, Critical, and Panic) from the switch stored in the file
/var/adm/silkworm.
The kern prefix identifies that the switch uses "kernel" syslogd facility to
dispatch error log messages to the syslogd daemon.
Syslogd CLI Commands
Below is a list of commands that are related to the syslogd configuration.
Please refer to the help pages of these commands for more details.
SAN switch 2/32 Version 4.0.2b Release Notes
switch:admin>syslogdipremove "IP address of the remote syslogd
host"
The following example shows how to disable sending of error log messages to
a previously configured remote syslogd host whose IP address is
192.168.148.189:
switch:admin> syslogdipremove 192.168.148.189
Please refer to syslog related manual pages on your UNIX system for the full
kern.debug /var/adm/silkworm
Fabric OS Commands
47