HP StorageWorks 2/32 - SAN Switch Release Note page 49

Note:
Switch PID Format enabled, so it is not necessary to perform the PID format change on
these switches.
The actual process of changing the PID format is quite simple. Telnet into each
switch in the fabric, and disable the switch using the switchDisable
command. Use the configure command to change the parameter as shown in
the following example:
Example
SAN switch 2/32 Version 4.0.2b Release Notes
All switches running any version of Fabric OS 4.x are shipped with the Core
switch:admin> switchdisable
switch:admin> configure
Configure...
Fabric parameters (yes, y, no, n): [no] yes
Domain: (1..239) [1]
R_A_TOV: (4000..120000) [10000]
E_D_TOV: (1000..5000) [2000]
Data field size: (256..2112) [2112]
Sequence Level Switching: (0..1) [0]
Disable Device Probing: (0..1) [0]
Suppress Class F Traffic: (0..1) [0]
SYNC IO mode: (0..1) [0]
VC Encoded Address Mode: (0..1) [0] 1
Core Switch PID Format: (0..1) [0] 1
Per-frame Route Priority: (0..1) [0]
Long Distance Fabric: (0..1) [0]
BB credit: (1..27) [16]
Updating the Core Switch PID Format
49