Cf_Vscale Command; Cf_Vpos Command - Sanyo PLC-ZM5000L - 5000 Lumens Manual

PLC-ZM5000/ZM5000L Expand Serial Command Functional Specifications
8.7.3

CF_VSCALE Command

Command "CF_VSCALE_%1" [CR]
"035" ---------------------- +35
"031" ---------------------- +31
ÿ
"002" ---------------------- +2
"001" ---------------------- +1
"000" ---------------------- ±0
" 01" --------------------- 1
%1
" 02" --------------------- 2
ÿ
" 31" --------------------- 31
" 32" --------------------- 32
"UP" --------------------- Increment setting value of Vscale by 1
"DN" --------------------- Decrement setting value of Vscale by 1
Set Vscale (Available only in the normal Power ON status)
*When the screen mode is not in "Custom", projector changes image mode into
Details Custom by receiving this command.
*When there is no signal detected, projector returns 101 and the command does
not execute.
Acceptable
Response
Unacceptable
8.7.4

CF_VPOS Command

Command "CF_VPOS_%1" [CR]
"015" --------------------- +15
"014" --------------------- +14
ÿ
"002" --------------------- +2
"001" --------------------- +1
"000" --------------------- ±0
" 01" --------------------- 1
%1
" 02" --------------------- 2
ÿ
" 14" --------------------- 14
" 15" --------------------- 15
"UP" --------------------- Increment setting value of Vposition by 1
"DN" --------------------- Decrement setting value of Vposition by 1
Set V Position (Available only in the normal Power ON status)
*When the screen mode is not in "Custom", projector changes image mode into
Details Custom by receiving this command.
*When there is no signal detected, projector returns 101 and the command does
not execute.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
33/89