Cf_Dline Command; Cf_Setpcadj Command - Sanyo PLC-ZM5000L - 5000 Lumens Manual

PLC-ZM5000/ZM5000L Expand Serial Command Functional Specifications
8.5.7

CF_DLINE Command

Command "CF_DLINE_%1" [CR]
"0100-nnnn" ----------- Directly specify setting value of Display Line
"nnnn" indicates maximum value, which is current value of (Total Line - Position V).
%1
"UP" ------------------- Increment setting value of Display Line by 1
"DN" ------------------- Decrement setting value of Display line by 1
Set setting value of Display Line in PC signal (Available only in the normal Power
ON status)
Details The value set by this command will not be stored in the projector's memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting.
Acceptable
Response
Unacceptable
8.5.8

CF_SETPCADJ Command

Command "CF_SETPCADJ_%1" [CR]
None
%1
"EXT11-60"
1. Apply setting value of PC adj. to the projecting image.
Projecting image can be corrected with this command as well as when PC control
command and Screen control command below directly apply its value to the
image. (Available only in the normal Power ON status)
0û CF_FSYNC
0û CF_TDOTS
0û CF_CLAMPPAHSE
Details
0û CF_Hÿ POS
0û CF_Vÿ POS
0û CF_DDOTS
0û CF_DLINE
2. When "EXT11-60" is specified in %1, "Ex Mode" (not like XGA1) is displayed in
"SYSTEM" menu.
Acceptable
Response
Unacceptable
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
26/89