NOTE
WARNING
Additional LAN3
LAN3 Configuration
The Thecus IP storage supports three Gigabit Ethernet ports for higher service
availability. If the model has HA function, the on board LAN3 may config for heart
beat link or it can be used as 3
choose Additional LAN 3 from the System Network menu, and the Additional
LAN3 Configuration screen appears. Press Apply to save your changes.
Additional LAN3 Configuration
Item
MAC Address
Jumbo Frame Support
IP
Netmask
Gateway
Link Detected
Lick Speed
Additional LAN
Other than on-board LAN port, Thecus IP storage supports additional NIC to be
added in its available PCI-e slot. For the details of additional NIC support list please
visit Thecus website.
http://www.thecus.com/sp_comlist.php
Once the additional NIC has installed into Thecus IP storage, the "Additional LANx"
is appeared under "System Network" category. Click the associated NIC to setup the
details.
The IP Segment of WAN/LAN1 and LAN2 should not overlap.
The IP address of the LAN2 interface should not be in the range of the
Start IP address and End IP address.
(For the model with 3
rd
individual LAN port. To configure these ports,
Description
Displays the MAC address of the LAN3 interface.
Enable or disable Jumbo Frame Support on the LAN3 interface.
Specifies the IP address of the LAN3 interface.
Specifies the Network Mask of the LAN3 interface.
When Thecus NAS as a DHCP server from LAN3, it can have
another route to balance traffic bandwidth for its DHCP
clients
Specifies the LAN3 port link status
Specifies the LAN3 port link speed
rd
LAN but W/O HA feature)
44