Replacing Damaged Hard Drives; Hard Drive Damage; Replacing A Hard Drive; Raid Auto-Rebuild - Thecus N16000 Series User Manual

Replacing Damaged Hard Drives

If you are using RAID 1, RAID 5, RAID 6, RADI50 or RAID 60 you can easily replace
a damaged hard drive in the Thecus IP storage while keeping your data secure with
the system's automatic data recovery.

Hard Drive Damage

When a hard drive is damaged and data in the RAID volume, the system OLED will
display warning message also the system beeps.

Replacing a Hard Drive

To replace a hard disk drive in Thecus IP storage:
1. Remove the tray with the damaged hard disk.
2. Unscrew the damaged hard disk and remove it from the tray.
3. Slide a new hard disk into the tray and fasten the screws.
4. Insert the hard disk tray back into Thecus IP storage until it snaps into place.
You can also lock it with a key if desired.
5. The LED blinks green when the HDD is accessed.

RAID Auto-Rebuild

When using RAID 1, 5, 6,10, 50 or 60 on Thecus IP storage, you can use the
auto-rebuild function when an error is detected.
1. When a hard disk fails the system beeps and/or an email notification is sent
to specified receivers.
2. Check the OLED to see which disk has failed.
3. Follow the steps mentioned above to replace the failed hard disk.
4. The system automatically recognizes the new hard disk and starts the
auto-rebuild sequence to resume its status before the hard disk crash.
122