Lan2 - Thecus N16000 Series User Manual

LAN2

LAN2 Configuration
The Thecus IP storage supports two Gigabit Ethernet ports for higher service
availability. To configure these ports, choose LAN2 from the System Network
menu, and the LAN2 Configuration screen appears. Press Apply to save your
changes.
LAN2 Configuration
Item
MAC Address
Jumbo Frame Support
IP
Netmask
Link Detected
Lick Speed
NOTE
DHCP Server Configuration
A DHCP server can be configured to assign IP addresses to devices connected to the
LAN2 port. To configure these ports, choose LAN2 from the System Network
menu.
DHCP Configuration
Item
DHCP Server
Lower IP Range
Highest IP in Range
Gateway
DNS Server
Description
Displays the MAC address of the LAN2 interface.
Enable or disable Jumbo Frame Support on the LAN2 interface.
Specifies the IP address of the LAN2 interface.
Specifies the Network Mask of the LAN2 interface.
Specifies the LAN2 port link status
Specifies the LAN2 port link speed
Before enabling Jumbo Frame Support, please make sure your network equipment
supports Jumbo Frame. If your equipment is incompatible, you might not be able to
connect to your Thecus IP storage.
Description
Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN2 interface.
Specifies the lower IP address of the DHCP range.
Specifies the highest IP address of the DHCP range.
Specifies gateway for the DHCP server service.
Displayed the DNS server IP address.
43