Additional Lan - Thecus N12000 series User Manual

Jumbo Frame Support
Link Type
IPv4/IPv6
Mode
IP
Netmask/Prefix Length
Gateway
Default gateway
Now under the networking, it will have "Link1" appear from network title bar.
To modify or delete LINK1, go to Link Aggregation setting page. Click on
to modify setting or click on
nd
certainly create 2 link aggregation by click
ports.

Additional LAN

Other than on-board LAN port, Thecus IP storage supports additional NIC to be
added in its available PCI-e slot. For the details of additional NIC support list please
visit Thecus website.
http://www.thecus.com/sp_comlist.php
Once the additional NIC has installed into Thecus IP storage, the "Additional LANx"
is appeared under "Networking" category. Click the associated NIC to setup the
details. Here is example to have Intel PRO/1000 PT Quad port installed from screen
shot below.
Enable or disable Jumbo Frame Support of associate interface on your
Thecus IP storage.
Select from drop down list for desired mode.
Click to enable IPv4/IPv6 for TCP/IP. The default is IPv4 enabled.
It has to be static IP with link aggregation been used.
IP address of link aggregation. .
Input netmask for IPv4 and Prefix length for IPv6.
Gateway for associate link aggregation
It can be choose from drop down list of default gateway been used for the
Thecus IP storage.
to delete this link aggregation. It can
60
if there are still available network