Lan2 - Thecus N16000 Series User Manual

WAN/LAN1 Configuration
Item
Host name
Domain name
WINS Server
MAC Address
Jumbo Frame Support
IP Sharing Mode
Link Aggregation
Set IP Address by:
Static / Dynamic
IP
Netmask
Gateway
DNS Server
NOTE
WARNING

LAN2

LAN2 Configuration
The Thecus IP storage supports two Gigabit Ethernet ports for higher service
availability. To configure these ports, choose LAN2 from the System Network
menu, and the LAN2 Configuration screen appears. Press Apply to save your
changes.
Description
Host name that identifies the Thecus IP storage on the network.
Specifies the domain name of Thecus IP storage.
To set a server name for NetBIOS computer.
MAC address of the network interface.
Enable or disable Jumbo Frame Support of the WAN/LAN1 interface on your
Thecus IP storage.
When enabled, PCs connected to the LAN2 port will be able to access the
WAN/LAN1.
Specifies whether WAN/LAN1 and LAN2 ports will be aggregated and act as
one port. There are 6 modes can be choose from:
Load Balance/Fail-over/Balance-XOR/802.3ad/Balance-TLB/Balance-ALB
You can choose a static IP or Dynamic IP, and input your network
configuration
IP address of the WAN/LAN1 interface.
Network mask, which is generally: 255.255.255.0
Default Gateway IP address.
Domain Name Service (DNS) server IP address.
• Only use Jumbo Frame settings when operating in a Gigabit environment
where all other clients have Jumbo Frame Setting enabled.
• If you are only using the WAN/LAN1 port, we suggest that you disable IP
Sharing Mode. This will result in higher throughput.
• A correct DNS setting is vital to networks services, such as SMTP and NTP.
• To use the Link Aggregation with "802.3ad selected" feature, please make sure
the networking equipment on the other end of Ethernet cable also supports
802.3ad protocol.
Most Fast Ethernet (10/100) Switches/Routers do not support Jumbo Frame and you will not
be able to connect to your N12000/N16000 after Jumbo Frame is turned on.
36