Finishing Up; Novell Netware Server Installation Instructions - HP D5970A - NetServer - LCII Configuration Manual

Chapter 8
NOTE

Finishing Up

14. Read the Release Notes.
15. Restart Windows NT or Windows 95 if you did not do so in Step 11.

Novell NetWare Server Installation Instructions

For each server operating under Novell NetWare and containing HP NetRAID
Series adapters to be managed over the network, install the HP NetRAID
Network Utilities as described below:
1. For NetWare 4.11 only, the file rpcbstub.nlm is a read-only file. This
file attribute must be changed to read/write before installing the HP
NetRAID Network Utilities on a client connected to NetWare through the
network. Exit to the DOS prompt and change the file attribute to r/w with
the attrib command. The file is located in the \system\ directory of
NetWare on the SYS volume.
2. Start the NetWare server and insert the "NetRAID Utilities for NetWare"
diskette.
3. At the NetWare console prompt, type load a:\raidinst.nlm
4. Choose Install Package.
5. To the question "Install registration server?" select yes or no.
Select yes if you want this server to be the Registration Server.
Select no if this server will not be the Registration Server. Enter the
name of the Registration Server when prompted.
6. Files are copied.
7. Enter and retype the password that will be required for access to this
server. Passwords are case-sensitive.
Managing Servers Over the Network
HP recommends that all servers and clients that manage
integrated HP NetRAID controllers (or HP NetRAID
Series adapters) over the network have the same hosts
file content. This prevents problems in resolving server
names and addresses.
85