Step K. Install Nos-Specific Configuration Utility - HP D5970A - NetServer - LCII Configuration Manual

Chapter 6

Step K. Install NOS-specific Configuration Utility

In this step, you install the configuration utility specific to Windows NT or
Novell NetWare.
If you are using Microsoft Windows NT, you install the HP NetRAID
Assistant utility. This is the Windows NT version of the utility you used to
configure your system in Chapter 5.
If you are using Novell NetWare, you install the HP NetRAID Config
utility for NetWare.
Chapter 10, "Understanding HP NetRAID Utilities," has menu maps of both of
these utilities. For complete information about these utilities, see the
HP NetRAID Series User Guide in Information Assistant.
Install the utility as described for the NOS version below.
Microsoft Windows NT 4.0
1. Select Start from the taskbar.
2. Choose Run from the Start menu.
3. Insert diskette #1, "NetRAID Assistant for WindowsNT and Windows95."
4. Type <d>:\setup at the Open: prompt, where <d> is the drive letter of
the diskette drive you are using.
5. Follow the on-screen instructions.
Novell NetWare 4.11, 4.11 SMP, SFTIII 4.11
1. Exit to the DOS prompt.
2. Insert the diskette called "NetRAID Utilities for NetWare."
3. Type Copy <d1>:\NetRAID\*.* <d2>:\nwserver, where <d1>
is the drive letter for the diskette drive and <d2> is the hard disk where
NetWare is installed. Press Enter.
4. To load the HP NetRAID Config utility, type
load <d2>:\nwserver\megamgr.nlm and press Enter at the
NetWare command prompt.
HP NetRAID Software
61