HP D5970A - NetServer - LCII Configuration Manual page 112

Chapter 11
No HP NetRAID Adapter
Problem: The HP NetRAID BIOS cannot communicate with the firmware on the
adapter.
Suggested solutions: Remove any HP NetRAID adapters from the PCI slots. If the
error message persists, see the Service and Support chapter of the HP NetServer
LH 3/LH 3r User Guide.
Configuration of NVRAM and drives mismatch
Run View/Add Configuration option of Configuration Utility.
Press any key to enter the Configuration Utility.
Problem: The configuration stored in NVRAM does not match the configuration
stored in the drives. All drives contain one set of configuration information, and
NVRAM contains a different set.
Suggested solution: Do the following to pick the correct configuration from either
NVRAM or from the disks.
1. Press any key to enter HP NetRAID Express Tools.
2. From the Configure menu, choose the View/Add Configuration option.
View/Add Configuration asks which configuration you want to view:
NVRAM or disk.
3. Use View/Add Configuration to examine both configurations.
4. Resolve the configuration mismatch by selecting and saving one of the
two configurations.
Configuration of NVRAM and drives mismatch for Host Adapter - x
Run View/Add Configuration option of Configuration Utility.
Press any key to enter the Configuration Utility.
Problem: You have installed one or more HP NetRAID-3Si adapters, and the
configuration stored in the NVRAM of adapter x does not match the
configuration stored in the drives. All drives on that adapter contain one set of
configuration information, and NVRAM contains a different set.
Suggested solution: Do the following to pick the correct configuration from either
NVRAM or from the disks.
1. Press any key to enter HP NetRAID Express Tools.
2. From the Configure menu, choose the View/Add Configuration option.
View/Add Configuration asks which configuration you want to view:
NVRAM or disk.
106
Troubleshooting