Step L. Run Hp Netraid Express Tools (Optional) - HP D5970A - NetServer - LCII Configuration Manual

Chapter 6
Novell NetWare 3.2
1. Exit to the DOS prompt.
2. Insert the diskette called "NetRAID Utilities for NetWare."
3. Type Copy <d1>:\NetRAID\*.* <d2>:\server.312, where
<d1> is the drive letter for the diskette drive and <d2> is the hard disk
where NetWare is installed. Press Enter.
4. To load the HP NetRAID Config utility, type
load <d2>:\nwserver\megamgr.nlm and press Enter at the
NetWare command prompt.

Step L. Run HP NetRAID Express Tools (optional)

After you have installed your software, you might need to run the HP NetRAID
Express Tools utility. Run HP NetRAID Express Tools if you need to do either of
the following:
Set the SCSI transfer rate if you are using either Fast/Wide or Ultra/Wide
devices with an external connection. The default SCSI transfer rate is
Ultra2, so you do not need to set the SCSI transfer rate if you are using
internal hot-swap mass storage only.
Disable the HP NetRAID BIOS to prevent booting from the HP NetRAID
subsystem.
HP NetRAID Express Tools is a configuration and management utility that
resides in a chip on the HP NetServer I/O board along with the HP NetRAID
BIOS and firmware. For more information about HP NetRAID Express Tools and
its functions, refer to the HP NetRAID Series User Guide in Information
Assistant.
To start HP NetRAID Express Tools:
1. Boot the host HP NetServer and watch for the flashing message:
Option: Experienced users may press <Ctrl> <m> for
HP NetRAID Express Tools now.
Firmware Initializing
2. While this message is flashing, press <Ctrl> <M> or <Ctrl> <m>. When
the system stops scanning, HP NetRAID Express Tools starts and displays
the Tools Management menu.
62
HP NetRAID Software