Using Hp Netraid Assistant To Manage Servers; Before Starting Hp Netraid Assistant - HP D5970A - NetServer - LCII Configuration Manual

Chapter 8
8. Edit the regserv.dat file located at sys:\etc\regserv.dat
Replace localhost with the name of the server that will be the
Registration Server for this network.
9. Edit the hosts file located at sys:\etc\hosts. It should contain the
IP address and name of each server with integrated HP NetRAID
controllers (or HP NetRAID Series adapters) to be managed over the
network.
10. Restart NetWare.
NOTE

Using HP NetRAID Assistant to Manage Servers

Before Starting HP NetRAID Assistant

The Registration Server must be running before any other servers are started.
If the Registration Server is a NetWare server, it must be running
reg_serv.nlm.
If the Registration Server is an NT server, it must be running the
NetRAID Registration Server icon (under the NetRAID program group).
To access an HP NetRAID Series adapter in a server from the network, the three
services listed below must be running. Start them in the order listed. You may set
them for automatic start, if desired.
1. NobleNet Portmapper: It should have been installed by the HP NetRAID
software and set for automatic start in Windows NT. In NetWare, load
rpcstart.nlm.
2. HP NetRAID Registration Server: Start it before the others by double-
clicking on its Windows icon or by loading NetWare module
reg_serv.nlm.
86
Managing Servers Over the Network
If the NetWare server is a Registration Server, the
reg_serv.nlm will be put in autoexec.ncf to
automatically start it. However, if the software was
installed previously, but not as a Registration Server,
edit the autoexec.ncf file to add the statement
load reg_serv.nlm so that the Registration Server
will automatically start under NetWare.