Step E. Boot Hp Netserver Navigator To Launch Hp Netraid Assistant; Boot Hp Netserver Navigator Cd-Rom; Boot Messages; Select Configure Disk Array - HP D5970A - NetServer - LCII Configuration Manual

Chapter 5
5. If necessary, you can use the Setup utility to change settings such as IRQs
or MP specification settings.
6. Press the F10 function key to save and exit.
7. In the Setup Configuration dialog box, press the Enter key to answer
"Yes" to the question "Save configuration and exit now?" The HP
NetServer reboots.
Step E. Boot HP NetServer Navigator to Launch
HP NetRAID Assistant

Boot HP NetServer Navigator CD-ROM

To launch the HP NetRAID Assistant, you must boot from the HP NetServer
Navigator CD-ROM. Ensure that all the SCSI devices power up before or at the
same time as the host computer.

Boot Messages

If you receive an HP NetRAID error message during the boot process, refer to
Chapter 11, "Troubleshooting," or to the online help in Information Assistant for
more information. Some power-up (boot) messages are routine.

Select Configure Disk Array

If HP Navigator asks you to set the date, time, and so on, do so. The HP
Navigator Main Menu then appears.
1. When the HP Navigator Main Menu is displayed, choose NetServer
Utilities.
2. Choose Disk Array Utility from the NetServer Utilities screen. This
launches the HP NetRAID Assistant utility.

Step F. Configure Arrays and Logical Drives

In this step, you will use Worksheets A and B to:
Configure the arrays of physical drives
Configure the logical drives
Configuration
41