4.
If installing a SAS drive, attach a SAS-to-SATA cable adapter to the connector on the SAS hard
drive as shown in the following figure.
NOTE:
Figure 5-46
5.
Push the hard disk drive into the selected bay until it snaps into place
figure.
Figure 5-47
6.
Attach a power cable
to the hard disk drive.
NOTE:
on the system board (for SATA HDDs) or SAS controller card (for SAS HDDs). To identify hard
disk drive connectors, refer to the workstation service label on the side access panel.
ENWW
SAS Drives require a separate SAS Controller plug-in card.
Attaching the cable adapter
Installing the HDD drive
to the drive, and attach a data cable
2
For SATA and SAS HDDs, connect data cables to lower-numbered drive connectors first
as shown in the following
from the SATA port or SAS controller
Removing and installing components 111