Installing the airflow guide
1.
Power down the workstation (see
2.
Disconnect power from the workstation (see
3.
Remove the side access panel (see
4.
Press the power cables, including P1, down toward the system board between the DIMM slots and
the internal bay, as shown in the following figure.
Figure 5-27
5.
Set the airflow guide into the chassis.
a.
Place the edge of the airflow guide
Figure 5-28
b.
Route the power and data cables through the opening next to the internal bay
ENWW
Predisassembly procedures on page
Positioning the chassis cables
Installing the airflow guide
Predisassembly procedures on page
Removing the side access panel on page
between DIMM socket #6 and the CPU heatsink.
Removing and installing components
69).
69).
72).
.
2
93