Optical Disk Drive (Desktop Configuration); Removing An Optical Drive (Desktop Configuration) - HP Z400 - Workstation Maintenance And Service Manual

Optical disk drive (desktop configuration)

This section describes how to remove and install an optical disk drive in the workstation desktop
configuration.

Removing an optical drive (desktop configuration)

1. Disconnect power from the system
2. Remove the side access panel
3. If your system has an airflow guide, remove it (see
4. Remove the front bezel
5. Disconnect the data
figure. (The connector colors might be different than shown in the figure.)
Figure 5-17
84 Chapter 5 Replacing components
(Predisassembly procedures on page
(Removing the side access panel on page
(Removing the front bezel on page
and power
2
Disconnecting the optical drive cables
Removing the airflow guide on page
75).
cables from the optical disk drive as shown in the following
69),
72).
92).
ENWW