Customer Self Repair; Pre-Disassembly Procedures - HP Xw8400 - Workstation - 4 GB RAM Technical Reference Manual

WARNING!
battery is handled improperly. Do not disassemble, crush, puncture, short external contacts, dispose of
in water or fire, or expose it to temperatures higher than 140 degrees F (60 degrees C).
NOTE: Batteries, battery packs, and accumulators should not be disposed of with general household
waste.

Customer Self Repair

Customer Self Repair (CSR) enables you to obtain replacement parts and install them yourself on your
workstation. The following table indicates which workstation components are customer-serviceable.
See http://www.hp.com/go/selfrepair/

Pre-disassembly procedures

Perform the following steps before servicing the workstation:
1. Remove or disengage any security devices that prohibit opening the workstation.
2. Close any open software applications.
3. Remove any diskettes or CDs from the workstation.
4. Exit the operating system.
5. Shut down the workstation and any peripheral devices that are connected to it.
6. Disconnect the power cord from the electrical outlet and then from the workstation.
7. Disconnect all peripheral device cables from the workstation.
50 Chapter 4 Removal and replacement procedures
This workstation contains a lithium battery. A risk of fire and chemical burn exists if the
for more information.
ENWW