Power Cord Requirements; Environmental Specifications - HP Xw8400 - Workstation - 4 GB RAM Technical Reference Manual

Power cord requirements

The power cord set (flexible cord or wall plug) received with this product meets the requirements for use
in the country where you purchased the equipment.
If you must obtain a power cord for a different country, you should purchase a power cord that is
approved for use in that country.
The power cord must be rated for the product and for the voltage and current marked on the product's
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and
current rating marked on the product. The length of the cord must be between 6 feet (1.8 m) and 12 feet
(3.6 m). If you have questions about the type of power cord to use, contact the HP authorized service
provider.
A power cord should be routed so that it is not likely to be walked on or pinched by items placed on it
or against it. Particular attention should be paid to the plug, electrical outlet, and the point where the
cord exits from the product.
NOTE: A 15AMP-capable (minimum) power cord must be used in with a 110-V power source. A
10AMP-capable (minimum) power cord should be used with a 220-V power source.

Environmental specifications

This section describes environmental specifications of your workstation.
Temperature
Humidity
Altitude
Shock
Vibration
10 Chapter 1 Product overview
Operating: 5 to 35°C (40 to 95°F)
Non-operating: -40 to 60°C (-40 to 140°F)
NOTE: Derate by one degree C (1.4 degrees F) for every 305m (1,000 ft.)
altitude over 1,524m (5,000 ft.).
Operating: 8 to 85% RH, non-condensing
Non-operating: 8 to 90% RH, non-condensing
Operating: 0 to 3,048m (10,000 ft.)
Non-operating: 0 to 9,144m (30,000 ft.)
Operating: ½-sine: 40g, 2-3ms
Non-operating:
●
½-sine: 160 cm/s, 2-3ms (~100g)
● square: 422 cm/s, 20g
NOTE: Values represent individual shock events and do not indicate repetitive
shock events.
Operating random: 0.5g (rms), 5-300 Hz
Non-operating random: 2.0g (rms), 10-500 Hz
NOTE: Values do not indicate continuous vibration.
ENWW