HP Xw8400 - Workstation - 4 GB RAM Technical Reference Manual page 84

3. Disconnect the memory riser power cable. Disconnect each memory card power cable from the
power connector on a memory card.
Figure 4-27
4. Remove the memory riser cards from the card cage by grasping each card at its corners and pulling
straight up. There is no need to unlatch the system board connectors when removing the riser
cards.
5. Open all memory slot latches. Use a small screwdriver for convenience.
Figure 4-28
74 Chapter 4 Removal and replacement procedures
Disconnect riser card power cable
Open memory slot latches
ENWW