Removing Memory Module - HP Xw8400 - Workstation - 4 GB RAM Technical Reference Manual

Removing memory module

1. Disconnect power from the system (
access panel
facing up.
CAUTION:
power off the workstation and unplug the power cord from the AC power outlet. Wait until the LED
on the back of the power supply turns off before removing memory. If you do not unplug the power
cord while installing memory, your memory modules might be damaged and the system will not
recognize the memory changes.
2. Press the green tab at the base of the memory fan (1) and lift it up (2) to expose the memory
modules.
Figure 4-15
3. Gently push out on the socket levers.
ENWW
(Access panel on page
To ensure that memory modules are not damaged during removal or installation,
Rotating the memory fan
Pre-disassembly procedures on page
57). Place the workstation on its side with the system board
Removing and replacing components
50), and remove the
65