Processor Heatsink; Removing The Cpu Heatsink - HP Xw8400 - Workstation - 4 GB RAM Technical Reference Manual

4. Attach a data cable from a SATA connector on the system board to the hard drive, and attach the
fifth drive power cable to the drive.
Figure 4-61
5. For a SAS hard drive, attach a SAS/SATA adapter to the connector on the hard drive. Attach a
data cable from a SAS connector on the system board to the hard drive, and attach a power cable
to the drive.

Processor heatsink

Removing the CPU heatsink

NOTE: The following illustrated CPU heatsink is typical of what you might have in your workstation.
Be aware that different variations of the CPU heatsinks exist, but the overall procedures listed are
sufficient to assist you in removing the CPU heatsink.
1. Shut down the workstation, and disconnect power from the system (
procedures on page
workstation on its side with the system board facing up.
ENWW
Attaching the data cable for the SATA hard drive in the fifth hard drive bay
50). Remove the access panel
Pre-disassembly
(Access panel on page
Removing and replacing components
57), and place the
93