HP Visualization Center sv6 Troubleshooting Manual page 28

troubleshooting your hp visualization center sv6
troubleshooting tree
This is a bit mismatch or a graphics card mismatch.
•
Invalid number of Visuals detected for one or more Slaves.
This is a bit mismatch or a graphics card mismatch.
•
SLS/d Extension major version mismatch in one or more
Slaves.
Update all Workstations to the latest graphics patches as described in
the sv6 Installation/User's Guide.
•
Internal error: cannot set mode
Bad SLS/d Monitor Configuration specified in X*screens file. Use a
different video timing file, or remove all Video timing information
from /etc/X11/X0screens to return to default resolution.
•
Cannot run Scalable Visualization with only one Slave.
Put the hostnames of the other slave nodes back into
/etc/X11/X0screens.
•
Could not recover from Compositor Reset.
Reboot the master and cycle power on the Compositor.
•
One or more Slaves failed to start.
Look at the front of each Workstation to determine which slave didn't
start. Refer to the "J6000 doesn't Power On" section.
•
One or more Slaves are down or unresponsive
Look at the front of each Workstation to see if any have errors. Refer
to the "Boot Time Problems" section.
•
Compositor communication has been lost.
Cycle power on compositor and reboot master
•
Internal error: call technical support.
Call Technical Support as directed in your HP Support Plan.
28
.
.
Chapter 1