Removing A Dimm - HP Pavilion xl900 - Desktop PC Service Manual

Removing a DIMM

1 Turn off the computer and all peripherals.
2 Disconnect the modem/phone cable.
3 Disconnect the power cord and all other
attached cables (such as the keyboard, mouse,
and monitor).
4 Remove the side panel (see "Removing the
Side Panel" on page 34).
5 If necessary to reach the DIMM socket, slide
the drive cage out (see "Sliding the Drive
Cage In and Out" on page 35).
6 If necessary to reach the DIMM socket, open
the back panel door (see "Opening the Back
Panel Door" on page 37).
7 Gently lay the computer on its side.
8 Locate the DIMM sockets on the motherboard.
9 Move any cabling out of the way, if necessary.
10 Push down on the two retaining clips on the
ends of the DIMM socket until the DIMM pops
out of the socket.
42
hp pavilion home pc
Filename: ma1rwsc.doc Title: HP-Print2k.dot
Template: HP-Print2K.dot Author: Ann Schmidt
Revision #: 198 Page: 42 of 70
11 Holding the DIMM by its edges only, lift it
away from the socket. Store it in its antistatic
packaging.
To install a new DIMM in this socket, see
"Installing a DIMM" on page 40.
Last Saved By: Jerry C. Stogsdill
Printed: 04/26/01 11:33 AM
Warning:
Do not pull the DIMM out of
the socket. Use the retaining clips to eject
the DIMM.
Avertissement :
Ne tirez pas
directement sur le module DIMM.
Servez-vous des clips pour éjecter le
module DIMM.