HP Pavilion xl900 - Desktop PC Service Manual page 23

8 Remove the two screws on the front of the hard
drive.
9 Pull the hard drive out through the front of the
drive cage.
10 If you are replacing the hard drive, remove the
screws (5) and lift the drive from the bracket.
Filename: ma1rwsc.doc Title: HP-Print2k.dot
Template: HP-Print2K.dot Author: Ann Schmidt
Revision #: 198 Page: 19 of 70
To install the hard drive:
1 Place the new hard drive into the bracket and
secure it with the screws (5).
2 Insert the drive bracket into the drive cage and
push it in until seated.
3 Install the two screws on the front of the hard
drive.
4 Connect the power and IDE cables to the back
of the hard drive.
Note:
5 Slide the drive cage in (see "Sliding the Drive
Cage In and Out" on page 8).
6 Replace the side panel (see "Replacing the
Side Panel" on page 27).
7 Replace the front drive cover (see "Replacing
the Front Drive Cover" on page 25).
Last Saved By: Jerry C. Stogsdill
Printed: 04/26/01 11:33 AM
Be sure to connect the IDE cable connector
labeled "Master" to the hard drive.
upgrading and servicing the pc
19