If The Thread Breaks During Sewing; Restarting From The Beginning; Resuming Embroidery After Turning Off The Power - Brother NQ3500D Operation Manual

Adjustments During the Embroidery Process

If the thread breaks during sewing

a
Press the "Start/Stop" button to stop the machine.
b
If the upper thread is broken, redo the upper
threading. If the bobbin thread is broken, press
and follow the directions in steps
the previous section to reset the bobbin.
c
Press .
d
Press , , or
correct number of stitches before the area where the
thread broke.
Memo
• If you cannot move back to the area where the
thread broke, press
move to the beginning position of that color, then
use , or
before where the thread broke.
e
Press to return to the original screen.
f
Press (Presser foot lifter button) to lower the
presser foot, and press the "Start/Stop" button to
continue sewing.

Restarting from the beginning

a
Press .
E-24
a e
through from
to move the needle back the
to select the color and
to move ahead to slightly
b
Press .
→ The embroidery frame moves, returning the needle to
the pattern's beginning position.
c
Press (Presser foot lifter button) to lower the
presser foot and start sewing.
Resuming embroidery after turning off the
power
The current color and stitch number are saved when
embroidery is stopped. The next time the machine is turned
on, you have the option to continue or delete the pattern.
Memo
• Even if the power goes out in the middle of
embroidery, the machine returns to the point
where embroidery was stopped when the
machine is turned on again.
1 Current stitch number when embroidery was stopped
Note
• Do not remove the embroidery unit or the
memory will no longer remember your design.
a
Turn the main power to ON.
b
Follow the instructions shown on the screen and
remove the embroidery frame.
→ The following message will appear.
1