Modem Module Cable - HP 4410t - Mobile Thin Client Maintenance And Service Manual

Removal and replacement procedures

Modem module cable

✎
The modem module cable is included in the Cable Kit, spare part number 536538-001.
Before removing the modem module cable, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Switch cover (see
b. Keyboard (see
c. Optical drive (see
d. Speakers (see
e. Palm rest (see
f. Solid-state module (see
g. Top cover (see
Remove the modem module cable:
1. Disconnect the modem module cable 1 from the modem module.
2. Release the modem module cable 2 from the clips built into the base enclosure.
3. Release the RJ-11 connector 3 from the clip built into the base enclosure.
4. Remove the modem module cable.
Reverse this procedure to install the modem module cable.
4–28
"Battery" on page
"Switch cover" on page
"Keyboard" on page 4-9)
"Optical drive" on page
"Speakers" on page 4-15)
"Palm rest" on page 4-16)
"Solid-state module" on page
"Top cover" on page 4-22)
4-7).
4-8)
4-13)
4-20)
Maintenance and Service Guide