Figure 47. Putting The Washer On The Stud; Figure 48. Securing The Grounding Stud - Allied Telesis AT-EN646 Installation Manual

Section II: Indoor Installation
AT-iMG646xx Series Intelligent Multiservice Gateway and AT-EN646 Enclosure Installation Guide
6. Disassemble the stud, removing all the washers and nuts except the
split ring washer.
7. Put the stud with the split ring washer on it through the gateway
grounding hole in the gateway, as shown in Figure 47.

Figure 47. Putting the Washer on the Stud

8. Secure the stud with its washer to the gateway grounding hole with a
#10-32 Kepnut, as shown in Figure 48.

Figure 48. Securing the Grounding Stud

1172
1192
75