Installing The Gateway; Installing The Gateway In The Enclosure - Allied Telesis AT-EN646 Installation Manual

Installing the Gateway

Installing the
Gateway in the
Enclosure
Section I: Outdoor Installation
AT-iMG646xx Series Intelligent Multiservice Gateway and AT-EN646 Enclosure Installation Guide
Installing the gateway and connecting all the wires consists of the following
procedures:
"Installing the Gateway in the Enclosure," next
"Preparing and Connecting the Power Cord" on page 58
"Mounting the Splice Tray on the Gateway" on page 60
"Connecting the Fiber Optic Cable" on page 61
"Connecting the Telephone Wires" on page 62
"Connecting the LAN Cables" on page 63
"Completing the Installation" on page 65
Note
For outdoor installation, you must install this unit in the enclosure,
which satisfies the requirement for installation in a restricted access
location.
To install the gateway, perform the following procedure:
1. Remove all components from the shipping package.
Note
Store the packaging material in a safe location. You must use the
original shipping material if you need to return the unit to Allied
Telesis.
2. Ensure that the following components are included in the gateway
package. If any item is missing or damaged, contact your Allied Telesis
sales representative for assistance.
An AT-iMG646xx series gateway
Accessory kit that contains: one washer, one Kepnut, four self-
tapping pan head Phillips screws, four short pan head machine
screws, four self-adhesive wire clips, and a DC terminal block
This installation guide
55