Connecting The Lan Cables; Figure 40. Telephone Wire Entrance; Figure 41. Connecting The Telephone Wires - Allied Telesis AT-EN646 Installation Manual

Connecting the
LAN Cables
Section I: Outdoor Installation
AT-iMG646xx Series Intelligent Multiservice Gateway and AT-EN646 Enclosure Installation Guide
Figure 40, cut a 1/4" "X" in it, and put it back in place.
Telephone Wire Entrance

Figure 40. Telephone Wire Entrance

2. Slip the telephone wire through the grommet.
3. Connect the telephone wires to each pair of telephone terminal posts
in the enclosure, as shown in Figure 41, at 5.3 in-lbs.

Figure 41. Connecting the Telephone Wires

4. Secure the telephone wire to the entrance with a UV-rated wire tie (not
provided).
5. Seal the grommet with electrical tape (not provided) and silicone
sealant (not provided).
To connect the LAN cables, perform the following procedure:
Note
Allied Telesis recommends that you fully wire all six ports to allow for
easy service expansion in the future.
859
63