Installing The Grounding Plate; Figure 5. Grounding Plate; Figure 6. Aligning The Grounding Plate - Allied Telesis AT-EN646 Installation Manual

Installing the Grounding Plate

Section I: Outdoor Installation
AT-iMG646xx Series Intelligent Multiservice Gateway and AT-EN646 Enclosure Installation Guide
To install the grounding plate, perform the following procedure:
1. Open the outer and inner doors of the enclosure.
2. Remove the grounding plate (shown in Figure 5) and the self-tapping
screw from the accessory kit.
Gateway Mounting Post
Ground Wire Post
Drop Cable Clamp
3. Align the notch in the grounding plate with the vertical support, and the
hole in the grounding plate with the hole in the back of the enclosure,
as shown in Figure 6.
Mounting Hole

Figure 6. Aligning the Grounding Plate

4. Use the self-tapping screw to secure the grounding plate to the
enclosure through the mounting hole in the grounding plate.
Strength Member Clamp

Figure 5. Grounding Plate

Vertical Support
Aramid Yarn and
Tracer Wire Post
841
842
35