Installing The Armored Drop Cable; Figure 12. Securing The Tracer Wire And Aramid Yarn; Figure 13. Location Of Fiber Optic Drop Cable And Ground Wire Entrance - Allied Telesis AT-EN646 Installation Manual

Chapter 3: Installing the Enclosure
Installing the
Armored Drop
Cable
40
3. Wrap the tracer wire around the base of the post under the washer.
Wrap the aramid yard around the post at least four times, just above
the tracer wire and under the washer, and tighten the nut, as shown in
Figure 12.
Aramid Yarn
Tracer Wire

Figure 12. Securing the Tracer Wire and Aramid Yarn

4. Trim the yarn back to the post.
To install the armored drop cable, perform the following procedure:.
All Countries: Install product in accordance with local and
National Electrical Codes.
1. Locate the fiber optic drop cable and ground wire entrance on the
enclosure, as shown in Figure 7.
Fiber Optic Drop Cable and Ground Wire Enclosure Entrance

Figure 13. Location of Fiber Optic Drop Cable and Ground Wire Entrance

2. Route the fiber optic drop cable to the enclosure entrance and mark
the entrance location on the cable.
3. Cut the cable 42 in. (106.7 cm) beyond the mark.
Tracer Wire
847
E8
Section I: Outdoor Installation
843