Figure 27. Setting The Fiber Cable In The Splice Tray; Figure 28. Securing The Pigtail - Allied Telesis AT-EN646 Installation Manual

Section I: Outdoor Installation
AT-iMG646xx Series Intelligent Multiservice Gateway and AT-EN646 Enclosure Installation Guide
4. Route the fiber cable 2-1/2 times around the splice tray to the splice
organizer and cut it to a length that will allow the splice to be placed in
the organizer, as shown in Figure 27.

Figure 27. Setting the Fiber Cable in the Splice Tray

5. Cut the SC/UPC pigtail cable (not provided) 29.25 in. (74.30 cm)
beyond the boot.
6. Strip the SC/UPC pigtail jacket to expose 13.75 in. (39.93 cm) of fiber.
7. Clean the fiber, and splice it to the pigtail, per the splice manufacturer's
instructions.
8. Route the pigtail once around the splice tray and out through the upper
left corner and secure it with another wire tie, as shown in Figure 28.
The pigtail should extend 15.5 in. from the splice tray.
9. Trim the wire ties close to the cables.

Figure 28. Securing the Pigtail

1182
1183
49