Appendix A: Using An Analog Phone With The Cisco Uc320W; Basic Calling Functions On Analog Phones - Cisco WIP320 User Manual

Using an Analog Phone with the Cisco
UC320W

Basic Calling Functions on Analog Phones

Cisco SPA300 and SPA500 Series IP Phones with Cisco Unified Communications UC320W
This appendix contains information about using an analog phone within the Unified
Communications System. The primary purpose of an analog phone is to allow
emergency calls if the system becomes available due to a power loss. It also can
be used to place and receive calls and is ideal for use as a hot phone (for more
information, see Using a Hot Phone, page
Refer to the following topics:
• Basic Calling Functions on Analog Phones, page 91
• Using Star Codes for Special Features on Analog Phones, page 92
Task
Placing a call
Answering a call
Holding and resuming a
call
35).
Instructions
1. Lift the receiver, or activate the speaker, if
applicable.
2. Dial an extension number or an external number.
You may need to press a digit such as 9 to get an
outside line.
Lift the receiver, or activate the speaker, if
applicable.
Press the hook flash button to place a call on hold. A
long tone sounds. You can dial another number, or
set aside the receiver. To resume the call, press the
flash hook button again.
A
91