Figure 3-27. Removing and Installing a Hard-Drive Carrier
1
thumbscrew
Installing a Hard-Drive Carrier
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
CAUTION:
Combining SATA and SAS hard-drives in the same sled configuration
is not supported.
1 Place the hard-drive carrier into the sled tray and slide into place. See
Figure 3-27.
2 Tighten the thumbscrew to secure the hard-drive carrier in place. See
Figure 3-27.
3 Replace the back cover. See "Installing the Back Cover" on page 135.
4 Replace the sled. See "Installing a Sled" on page 130.
2
hard-drive carrier
Installing System Components
163