Installing The Back Cover; Cooling Shroud; Removing The Cooling Shroud - Dell PowerEdge C8000 Hardware Owner's Manual

Installing the Back Cover

NOTE:
It is recommended that you always use a static mat and static strap while
working on components in the interior of the system.
1 Place the cover on the sled tray and slide it towards the front of the sled
tray so that the screw holes on the back cover align with the sled tray. See
Figure 3-8.
2 Replace the two screws securing the back cover to the sled tray. See
Figure 3-8.

Cooling Shroud

Removing the Cooling Shroud

CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
CAUTION:
Never operate your system with the cooling shroud removed. The
system may get overheated quickly, resulting in shutdown of the system and loss of
data.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 129.
2 Remove the two screws securing the cooling shroud to the sled tray. See
Figure 3-9.
3 Press the shroud release lever toward the right of the sled.
4 Lift the shroud up to disengage the anchor tab from the heat sink. See
Figure 3-9.
Installing System Components
135