Dell PowerEdge C8000 Hardware Owner's Manual page 176

5 You must route the cables properly on the sled tray to prevent them from
being pinched or crimped.
6 Install the node power distribution board. See "Installing the Node Power
Distribution Board" on page 170.
7 Install the interposer extender to the new board. See "Installing the
Interposer Extender" on page 168.
8 Install the hard-drive tray. See "Installing the Hard-Drive Tray" on
page 166.
9 Install the hard-drives. See "Installing a Hard-Drive Carrier" on page 163.
10 Install the SD card reader support bracket. See "Installing the SD Card
Reader Support Bracket" on page 162.
11 Install the SD card reader. See "Installing the SD Card Reader" on
page 160.
12 Transfer the processors to the new system board. See "Removing a
Processor" on page 140 and "Installing a Processor" on page 142.
13 Remove the memory modules and transfer them to the same locations on
the new board. See "Removing Memory Modules" on page 146 and
"Installing Memory Modules" on page 147.
14 Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 136.
15 If applicable, install the mezzanine card. See "Installing the Infiniband
Mezzanine Card" on page 154 or "Installing the 10 GbE Mezzanine Card"
on page 157.
16 Install the expansion card. See "Installing the Expansion Card" on
page 149.
17 Replace the front cover. See "Installing the Front Cover" on page 133.
18 Replace the back cover. See "Installing the Back Cover" on page 135.
19 Replace the sled. See "Installing a Sled" on page 130.
176
Installing System Components