Installing The Interposer Extender - Dell PowerEdge C8000 Hardware Owner's Manual

Figure 3-30. Removing and Installing the Interposer Extender
1 screws (2)
3 power cable

Installing the Interposer Extender

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Hold the card by its edges, position the interposer extender so that the
edge connector aligns with the system board connector. See Figure 3-30.
2 Insert the card edge connector firmly into the system board connector
until the card is fully seated.
3 Replace the two screws securing the interposer extender to the sled tray.
See Figure 3-30.
4 Connect the power cable to the interposer extender. Press down on the
locking tab to secure the power cable. See Figure 3-30.
168
Installing System Components
Many repairs may only be done by a certified service technician. You
2 interposer extender